Navigation · Herringbone
Navigation Herringbone.
The same rigid core, the same décor sheet and the same measured colour as the long plank — cut short and laid at 45°. Everything on this page is the herringbone cut. Quantities from the plank sheet will not carry over.
Piece and pack
- Piece
- 100 × 600 mm
- Thickness
- 7 mm
- Pack
- 1.2 m²
- Pieces per pack
- 20
- Core
- Rigid SPC
- Bevel
- Micro-bevel, four sides
- Click
- Unilin
Cutting allowance
10–15%
Allow 10–15% over the measured floor area. Herringbone is cut at an angle at every perimeter, so the offcut is larger than a plank floor and cannot be reused along the opposite wall.
This is the number to carry into the order. A quantity calculated from the plank sheet will run short, and it will run short in the middle of the installation.
A and B
Herringbone needs two handed pieces. The factory makes a whole plate left and a whole plate right, and every pack holds an equal count of each — 10 A and 10 B. They are not interchangeable, and a pack is not split across two rooms.
Laying
Set out from the centre line of the room, not from a wall. One piece to each arm — the standard bond. Doubling or tripling the arm is a variation, not the default. Perimeter expansion gap as for the plank; the same click profile and the same four-sided micro-bevel.
The six colours
Each is the colour measured from the real piece and published on its model page. The herringbone carries the identical reference — same décor, same lock.
| Capri 747 | #AE8558 | Open the model |
|---|---|---|
| Menton 1018 | #B4A089 | Open the model |
| Antwerp 1014 | #9A7957 | Open the model |
| Sitges 1140-09 | #B09C83 | Open the model |
| Biarritz 612 | #AB967B | Open the model |
| Cascais 626 | #705C4B | Open the model |
Files: The data sheet and DWG floor hatch on each model page apply to the plank cut.